I have started creating my light source by molding the copper wire into a “U” shape (look at the images below) and soldering the wire to both sides of the battery holder to attach the battery holder and the wire. Then I inserted the CR2032 watch battery into the battery holder; fortunately, it fitted; however, the battery would not stay inside the battery holder. So I had to use a minimalistic amount of tape to hold the battery inside the battery holder. Before I moved any further with my design, I had to check if there were any voltage to allow my design to create any sort of light. Unfortunately, there was no voltage, and I had to think of a solution. After rethinking why there wasn’t any voltage, Mr. Hussack suggested cutting the copper wire at the bottom of the battery holder, disconnecting the copper wire., surprisingly there was the voltage after cutting the wire in half.

Since there is voltage, I continued with my design by attaching a switch to one side of the copper wire. I cut one side of the wire into half, soldered the wire to one metal piece of the switch, and soldered the copper wire that was cut off to the other metal piece of the switch. Then I twisted the longer leg of the LED to the side where the switch is and the other leg to the other side of the copper wire, but the light did not turn on even if I turned the switch on. So I decided to try the same thing with a different LED light in case the other one had issues. When I attached the other LED light, it lit up! After I saw the light lit up, I soldered the legs of the LED to the copper wire to make it remain there.

IMG_2214

To finalize my design, I attached my light source to the lid of a jar/jug by using hot glue. I ran into some challenges finding a jar, so I used a jug, which worked just as well. Then I turned on the switch and closed the lid of the jug. Under the light, I could not tell how bright the light was under the light, so I went to a darker place to test out how bright the light was. Unexpectedly it was pretty bright.

The light successfully worked, but I decided to decorate the jug after getting feedback from peers who said that the jug looked dull and could be decorated. I used thin lavender paper and wrapped the jug with it, and that is how I made my light/lamp!