Making the outline:

The first step was quite easy, but the hard part of to make sure the wires won’t collapse while we stick the lamp chimney on it.

Connecting batteries with the light bulb:

It’s pretty complicated to combine the wire with the light bulb, we have tried a few times because the light always flickers and we also charge the batteries in the wrong direction. But Mr.Diego helped us a lot during this process.

Connecting the circuit of the battery, light bulb, and button:

It was hard to combine these two wires with the button, because they aren’t firm, when we finally put on one wire, the other one falls down.

Picture of the final product:

The light was flickering while we test it, so we use tape to reinforce where those two wires are connected.

Video of testing the final project:

After feedback, the final final product:

 

This process was well done after reinforcing the connection between the wires.

Gathered improvements:

We gathered some improvements from Mr.Hussack about beautifying the base and the lamp chimney, so we stick some white tape on the bottom and use scissors to prune the edge of the lamp chimney and change the rubberized fabric into scotch tape (to stick the lamp chimney).