I started out with the idea of decorating my table with a lamp. I listed out what i liked and after doing that i felt like i should go with a tech theme so i had some computer patterns running on some side. During this process i learnt loads of skills in fusion. For example, viewCube, Sketch, Rectangle, Circle, Off set, circular patterns, Construction line, Arc/scale sketch and how to use text. I did struggle using these tools at first but after practice and the help of my friends i got better with them. I would tell incoming students that are going to do this project to make sure you double check that you glued all your pieces correctly before you put rubber bands on and leaving it on the rack. If i would go back in time i would defiantly take a screen shot and send it to Ms. Kim to approve before sending it to the laser cutter since i missed a lot of holes i was suppose to make so it could save me time.  I really liked this course and i feel like there really isn’t much to improve on but it would have been really nice if we had Ms.Kim for the whole time to keep us away from small mistakes.